Noshok 1950 Series Compact Smart System 5-Digit Process M Instrukcja Użytkownika Pobierz pdf (Strona 11)

6.5 MODULE 5 - SERIAL SETUP PARAMETERS (5-SEr)

The Serial Setup Parameters are only active when the optional RS232 or RS485 serial communications module is installed in the meter.

PARAMETER MENU

button or user input manual reset, serial reset command or meter power

cycle. When the user input or

RST button is activated (momentary action),

the corresponding “on” output is reset immediately and remains off until the

trigger point is crossed again. (Previously latched alarms will be off if power

up Display Value is lower than setpoint value.)

L-dLY = Latch with delay reset action; This action latches the output on at the

trigger point per the Setpoint Action shown in Setpoint Output Figures. Latch

means that the output can only be turned off by the front panel

RST button

or user input manual reset, serial reset command or meter power cycle. When

the user input or

RST button is activated (momentary action), the meter

delays the event until the corresponding “on” output crosses the trigger off

point. (Previously latched outputs are off if power up Display Value is lower

than setpoint value. During a power cycle, the meter erases a previous

L-dLY

reset if it is not activated at power up.)

Setpoint Output Reset Actions

This parameter enables the RST button or user input to reset the output when

the display is reset.

Note: For this parameter to operate, the

RST button or User Input being used

must be set to

dSP and the Input value must be displayed. If these conditions are

not met, the output will not reset.

YES

rEn-n

OUTPUT RESET WITH DISPLAY RESET

YESNO

When YES, the output is disabled (after a power up) until the trigger point is

crossed. Once the output is on, the output operates normally per the Setpoint

Action and Output Reset action.

Stb-n

STANDBY OPERATION

YESNO

This parameter enables the backlight 1950 to switch the backlight color when

the output state changes. This parameter is only active for the backlight version.

CHANGE DISPLAY COLOR w/OUTPUT STATE

ChC-n

YESNO

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Komentarze do niniejszej Instrukcji

Brak uwag

Noshok 1950 Series Compact Smart System 5-Digit Process M Instrukcja Użytkownika Strona 11

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Noshok 1950 Series Compact Smart System 5-Digit Process M